Παράθεση:
Αρχικό μήνυμα απο vagos
Πολύ ψιλή αμμοβολή;
Θεωρητικά δεν θα κάνει ζημιά.
|
http://www.luxfercylinders.com/suppo...inum-alloy-l6x
Παράθεση:
a) All-metal Luxfer 6061 aluminum alloy (L6X®) cylinders—To remove paint from an all-metal cylinder and prepare the surface for repainting, blast with plastic, glass or other soft media just long enough to remove most of the old paint. Do not blast with sand, steel, grit or aluminum oxide media, which are too abrasive. Heavy or improper blasting with hard or overly abrasive media removes metal as well as paint from the cylinder, which can thin the cylinder wall and make the cylinder unsafe to fill or use. Improper blasting also obliterates stamped markings and damages the outer surface of the cylinder.
Never use corrosive, caustic or acidic paint strippers or solvents to remove paint. Never use burning or torching techniques. Do not use knives or other sharp instruments to remove labels.
Once paint has been removed, use a neutral, mild, water-based detergent to wash the cylinder. Rinse the cylinder well and thoroughly dry it at a metal temperature not exceeding 160 degrees F (70 degrees C). Carefully inspect the cylinder surface for damage and corrosion in accordance with all applicable regulations. If the cylinder passes the inspection, it is ready for repainting.
|
Σε ένα άλλο technical bulletin η luxfer προτείνει τη χρήση paint remover σε μορφή gel (αυτό που αναφέρει ο Δημήτρης παραπάνω).
Ως επι το πλείστον, απ' οτι κατάλαβα χρησιμοποιούν το "Nitromors" το οποίο κυκλοφορεί και στην Έλλαδα. Το πρόβλημα είναι οτι εδώ και καιρό έχουν αλλάξει τις συνθέσεις στα removers για να γίνουν πιο φιλικά στο περιβάλλον, με αποτέλεσμα να γίνουν τόσο mild ώστε να μην μπορείς να ξεβάψεις ούτε τα νύχια σου.....
Πιο πολύ με απασχολεί το μετά.... άντε και το γδύσαμε το μπουκάλι με τον α' η β' τρόπο...... μετά τι κάνουμε ? Το αφήνουμε όπως είναι ? πρέπει να του περάσουμε κάποιο αντιδιαβρωτικό ?